Home           I have added more to the bottom of this page on how i do magnetic signs wet using my rubber roller scroll down and take a look see. Let me know what you think

cut border on computer trim off top for place to tape down.	Tape top of decal to board with duct tape.	Remove liner from decal	When doing wet  spray both surfaces. with RAPID-TAC
			SEE HOW EASY IT IS WITH THE RUBBER ROLLER

Roll down wet surface a little          Roll over several times from the       Spray mask with rapid-tac  remove  mask        Roll back over   practice makes perfect                      center out                                     the mask just about floats off.                                                I AM ON E-BAY

LOOK UNDER    SIGN SUPPLIES           VINYL SIGN SUPPLIES             SIGN MAKING         

           THIS IS HOW I DO MAGNETIC SIGNS WET WITH MY RUBBER ROLLER TRY IT YOU WILL LOVE HOW IT WORKS.  ALSO WORKS GREAT ON CORO AND ALUM CORE.  SOLD OUT OF ROLLER FOR NOW.

I cut a border the same size as the magnetic sign will be,  pick the vinyl leaving the borders as shown.	Pre-mask as usual use the roller to roll down the application tape.	After pre masking trim the sign to the borders now you are ready to place on the magnetic blank.	Wet both the vinyl and magnetic blank with rapid-tac real good .roll from the center out. Leave the mask on at this stage.
	Before removing the mask. trim around the borders.You can bend the magnetic to break. at this point the pre-mask should just about float off/ Blot the sign with paper towel. Re roll sign.		This the last and most important step is to round corner the magnetic sign. The corners are first to fail. If you don't have one cut around  a coin works just as good but round corner. Hope all this helps some Thanks Henry G

This is how i do magnetic signs in my sign shop it may not be the best way but this is how you can use the roller to apply the vinyl wet. I like a product call rapid-tac get at any sign supply co.  For best result use lots of it and roll from the center out  I have made many magnetic signs and not had any  failures that i know of. What i like is you don't have to get the magnetic piece square the computer does that for you. All you have to do is trim to the right size border. If you like this send me  a e-mail goines@brmemc.net      Thanks for looking   Henry Goines